I T Power Recommended

Mandatory Requirement for Installation of Computer Equipment Environmental Conditions:

It is customer’s responsibility to provide suitable place for installation (details of which are given below), within the time of planned delivery period. Any financial charges, incurred due to non-availability of required site, will be customer’s responsibility.

A. ELECRICAL POWER VOLTAGE

Operational Voltage 220 V -240 V
Frequency 50 Hz
Phase Single
Earth Should be properly electrically grounded (less than 3 VAC build up when checked with a volt meter between N-E).
Electrical Line for PC Should be free from any other inductive load device.
Power Outlet Should be 15 or 5 amperes 3-pin property grounded sockets.
Power Plug Must be 3 pins.
Stabilizer Should be of international standard, surge protected.

C. ATMOSPHRIC

  1. Equipment should be installed at a place where it is easily accessible for servicing.
  2. Rear of equipment should have at least half foot clearance from the wall.
  3. Equipment should be kept on a non-conductive surface for better result.
  4. There must not be any high voltage line, concealed or unconcealed near the equipment.
  5. Use of UPS (Uninterruptible Power Supply) is recommended.

B. ATMOSPHERIC

Temperature Ranges 10 to 35 (air-conditioning is highly recommended).
Relative Humidity 20% to 70% (non-condensing)
Altitude Sea level to 15,000 ft
Storage Temperature 6 to 40 C
Room Environment Must be dust free.
Room Carpeting Synthetic carpet not recommended due to Electro static charges build-up. Any other carpet not generating static Electricity while moving around in the room is acceptable. It is customer’s responsibility to provide Electromagnetic Interference free environment.

D. RECOMMENDATIONS

  1. Always take the backup of the data stored in the Hard Disk.
  2. Always use Original Software Packages (to minimize exposure due to computer viruses).
  3. Protect the System from virus invasion.
  4. Avoid using outside floppy diskettes.
  5. Do not place your floppy diskettes on top of computer.
  6. Always connect / disconnect your peripheral devices (printer-tape drives, USB-Mass Storage etc) or Connect cables only after turning off power to computer & peripheral devices.